Deltec Cozmo Uživatelský manuál stáhnout pdf (Strana 28)

About the Pump

Before using the pump for the first

time

Inserting a battery, programming the regional settings (if

required), and setting the time and date are the first

things you need to do when you get your pump. During

typical use, you can expect an alkaline battery to last

approximately 1 month (the “Vibrate” alert uses up

battery power faster).

Insert a battery

1. Put the edge of a coin into the

slot on the battery cap and

turn it counterclockwise (left)

to open it (see Figure 4).

Remove the old battery. Dis-

card used batteries according

to local laws and requirements.

2. Insert one “AAA” (IEC LR03)

alkaline battery into the com-

partment, making sure the +

side goes in first (see Figure 5);

if you insert the battery wrong,

the pump will not start.

☞

Caution: Do not use

NiCad, nickel metal

hydride, carbon zinc

(heavy duty), lithium or

any rechargeable batteries.

They will not power the

pump properly, and the

battery life indicator on the

home screen may not show

the correct amount.

3. Place the battery cap back

over the compartment. Push

down and turn the cap clockwise (right). Again use a

coin to tighten the cap. Make sure the cap is on tight.

If you insert a new battery and the pump doesn’t turn

on, check to make sure that the battery is in the correct

orientation (the + side goes in first). If it still doesn’t

turn on, try a new battery.

Once the battery is correctly inserted, the pump turns

on automatically and performs “self tests” to make sure

all the systems are working properly, and then stops at

the “home screen.”

Figure 4

Figure 5

2002-09-16 D. Zu

«cozmo-turn-batt

D. Zurn, 2001-08-29

needle-attach.ai

2002-09-16 D. Zurn

«cozmo-insert-AAA.eps»

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 136 137

Komentáře k této Příručce

Žádné komentáře

Deltec Cozmo Uživatelský manuál Strana 28

Komentáře k této Příručce